This is the latest version of our adjustable front track bar for the Ford Superduty. Constructed of 1.5in x .375 wall tubing this track bar is incredibly strong. It also uses a center adjuster to make centering the front axle much easier once its installed on the truck. With this there is no need to remove, adjust a rod end, and reinstall. On this track bar we utilize bushings and sleeves at both ends of the track bar. This allows deflection when needed and wont bind or limit the suspension travel at any height. The factory track bar uses a balljoint at the axle side which can be costly and time consuming to deal with when needing replaced. This track bar uses a custom bracket that was designed using 3D software and it laser cut and machined to bolt in place of the balljoint end on the axle housing. This bracket will also raise the pivot point up to keep the track bar on a more suitable plane. This was done to eliminate as much side to side movement of the axle as the suspension cycles.